WWWBoard New Message: Message 151: Re: FS4000US SCSI does not work
WWWBoard: Message 151
[ Follow Ups ] [ Post Followup ] [ ]
|
|
Posted by George on 07/09/02 at 2:32 PM
Subject: Re: FS4000US SCSI does not work
Message Posted
|
|
|
|
Dear JeffMany thanks for your adviceThe IOMEGA board is a jaz pci ultra card. It is configurable for either SCSI 1 or 2 and I have configured it for SCSI 2I did uninstall the Canoscan through the device manager and also uninstalled the drivers with Canon's DelFxEx utility and switched the computer off. I then connected the SCSI cable, switched on the scanner and rebooted the PC.Windows goes through the found new hardware routine and installs the scanner and drivers.Still no success.I use photoshop 5.0When I start the import process I get a transmission error (0x000d0026)"could not complete the import command because there is no scanner installed"I have tried Vuescan and it works perfectly using the SCSI set up so I guess I'll not use Canon's FilmGet.Any further thoughts?RgdsGeorge: Is the IOMEGA card a SCSI-2 card or SCSI-1 ?: The FS4000 uses a SCSI-2 interface.: Also, Did you uninstall the scanner drivers, reboot, and reinstall after hooking up the SCSI cable?: Good Luck!: Jeff: : : It works ell with USB but I cannot get it to work with my IOMEGA SCSI card. Have tried changing ID numbers. I also have a HP6250 scanner connected on the same SCSI line (it works perfectly)through the FS4000. I have ensured different id's and also SCSI termination is at the HP scanner.Have also tried FS4000 exclusively on the SCSI port without success. Does anyone have any suggestions?
|
|
|
